ANZSIC 2142

Aluminium Rolling, Drawing, Extruding

Division C — Manufacturing

Also classified as:
UN ISIC Rev. 4 2420 ≈ UN ISIC Rev. 4 2591 ≈ UN ISIC Rev. 4 2599 ≈ EU NACE Rev. 2.1 25.91 ≈ EU NACE Rev. 2.1 25.92 ≈ EU NACE Rev. 2.1 25.93 ≈ EU NACE Rev. 2.1 25.94 ≈ EU NACE Rev. 2.1 25.99 ≈ NA NAICS 2022 —
ISIC ↔ NACE crosswalk → ISIC ↔ NAICS crosswalk →

GTIAS Industry Analysis Available

This ANZSIC class maps to a fully analysed industry with an 81-attribute GTIAS scorecard, risk scenarios, and 42+ strategic frameworks.

View Industry Analysis →

About This Industry

This class consists of units mainly engaged in hot or cold rolling, drawing or extruding aluminium. Also included are units mainly engaged in manufacturing aluminium powders or flakes.

Primary Activities

  • Aluminium foil, household, manufacturing
  • Aluminium rolling, drawing or extruding
  • Bar, aluminium, manufacturing
  • Foil, aluminium, manufacturing
  • Paper-backed aluminium foil manufacturing
  • Pipe, aluminium, manufacturing
  • Plastic-coated aluminium foil manufacturing
  • Plate, aluminium, manufacturing
  • Powder or flake, aluminium, manufacturing
  • Rod, aluminium, manufacturing
  • Section, aluminium, rolling, drawing or extruding
  • Sheet, aluminium, manufacturing
  • Strip, aluminium, manufacturing
  • Tube, aluminium, manufacturing
  • Wire, aluminium, manufacturing

Exclusions / References

Units mainly engaged in:

  • casting aluminium shapes are included in Class 2132 Aluminium Smelting; and
  • manufacturing stranded, braided or insulated aluminium wire, cable or strip are included in Class 2431 Electric Cable and Wire Manufacturing.

ISIC Rev. 4 Equivalents

ANZSIC 2142 maps to the following ISIC Rev. 4 classes:

View the full ANZSIC ↔ ISIC alignment table →